Anyone able to cut a Japanese JM pickguard from custom material?
- smjenkins
- PAT. # 2.972.923
- Posts: 1559
- Joined: Fri Oct 08, 2010 5:45 am
- Location: The Emerald Fucking City
Anyone able to cut a Japanese JM pickguard from custom material?
I've got a Japanese JM that I'm hoping to replace the pickguard with a blue flower one. I've got a sheet of w/b/w/blue flower material. Any suggestions on someone who could make a Japanese JM guard from this material? I asked WD and they wouldn't do it.
- Sweetfinger
- PAT. # 2.972.923
- Posts: 460
- Joined: Sun Nov 03, 2019 3:23 pm
Re: Anyone able to cut a Japanese JM pickguard from custom material?
I suppose I could.
- guitalias
- PAT. # 2.972.923
- Posts: 148
- Joined: Mon Apr 20, 2020 10:04 pm
Re: Anyone able to cut a Japanese JM pickguard from custom material?
If you can source a dxf file of the pickguard it could be laser cut or water jet cut. If you want bevelled edges, cut a 1/4 inch/6mm mdf template. Use thin double side tape to join template & cut pickguard, then bevel edges with router.
Instructions for If you think of someone with these skills & equipment, I realise you were asking for a supplier.
Instructions for If you think of someone with these skills & equipment, I realise you were asking for a supplier.