Trem unit and signal disruption but only for bridge pickup

For help with setups and other technical issues.
Post Reply
User avatar
VANRNR
PAT PEND
PAT PEND
Posts: 5
Joined: Sun Jul 03, 2022 4:29 am

Trem unit and signal disruption but only for bridge pickup

Post by VANRNR » Thu Aug 04, 2022 10:50 am

The guitar is an American professional II with the Panorama trem unit. Using the bridge pick up only, and regardless of whether it’s being tapped or not, the signal will randomly diminish in volume and quality, but if I work the tremolo arm vigorously in a more exaggerated sense than I would while playing (think repeated divebombs), the signal strength of the bridge pick up will return. This does not happen when using the neck, combined or the rhythm circuit. Things will rock along with no disruption for some random period of time and then the pattern repeats.

My first thought was that the grounding wire beneath the tremolo had depressed into the finish and was no longer making a good ground connection to the plate. This was my best guess even though it was only happening with the bridge pick up. So, I exposed more of the ground wire and also folded a very small wedge of aluminum foil under the wire to enhance the contact with the tremolo plate. This did not solve the problem. (I also inspected the cavity to make sure that the trem unit wasn’t in some way catching on the ground wire and saw nothing unusual). Next, I rigged wire to connect directly from a string to the tremolo plate to see if that would clearly demonstrate a grounding issue, but it made no difference.

I’m stumped, and would appreciate any ideas you folks may have. Thanks!

User avatar
timtam
PAT. # 2.972.923
PAT. # 2.972.923
Posts: 2305
Joined: Sun Oct 22, 2017 2:42 am
Location: Melbourne

Re: Trem unit and signal disruption but only for bridge pickup

Post by timtam » Thu Aug 04, 2022 6:17 pm

That's a weird one. Since the bridge pickup is tapped on the Am Pro II, and that's done from a push-push switch - that also appears to carry the ground connection for the trem - that's where I would be looking. See PDF below. Look for possible shorts between bare wire ends, poor solder joints, etc. BTW the wire colours to the switch part are apparently drawn wrong in the PDF.
https://www.fmicassets.com/Damroot/Orig ... master.pdf
"I just knew I wanted to make a sound that was the complete opposite of a Les Paul, and that’s pretty much a Jaguar." Rowland S. Howard.

User avatar
camilonava27
PAT PEND
PAT PEND
Posts: 49
Joined: Thu Apr 29, 2021 12:50 am

Re: Trem unit and signal disruption but only for bridge pickup

Post by camilonava27 » Fri Aug 05, 2022 2:35 pm

The ground wire for the trem unit should be connected to the push push switch where the pickup is tapped, check that out. Good luck!

Post Reply