I’m trying to test out HX Stomp amp profiles from my pedalboard by running into my Apollo but notice everything sounds terrible and there’s a high end modulation happening too.
Any tips for running the Stomp into Apollo into Logic X?
Can’t use the Stomp as an interface as my delay and reverb on my board come after the stomp amps and I won’t be able to hear them
Stomp into Logic sounds terrible…..
- mavsbball
- PAT. # 2.972.923
- Posts: 215
- Joined: Tue Oct 10, 2006 7:05 am
- fleezinator
- PAT PEND
- Posts: 25
- Joined: Mon Apr 27, 2020 8:39 am
Re: Stomp into Logic sounds terrible…..
“ my delay and reverb on my board come after the stomp amps”
Is that to say you’ve got a send/return block just after your amps in the stomp signal chain? If, not have you considered that? That way you just use the stomp as the interface with your entire board signal in to Logic
Is that to say you’ve got a send/return block just after your amps in the stomp signal chain? If, not have you considered that? That way you just use the stomp as the interface with your entire board signal in to Logic
- mcatano
- PAT. # 2.972.923
- Posts: 324
- Joined: Fri Feb 16, 2007 3:01 pm
Re: Stomp into Logic sounds terrible…..
Are you using an amp model/cab sim in the HX stomp?
If so, do you have pedals running *after* the cab sim etc?
If you're not using an amp/cab sim in the HX, do you have one set up in logic?
Can you give a little more detail about what your actual signal chain is both in and out of the box?
If so, do you have pedals running *after* the cab sim etc?
If you're not using an amp/cab sim in the HX, do you have one set up in logic?
Can you give a little more detail about what your actual signal chain is both in and out of the box?