Got this head from Guitar Center. I think it needs new caps. The reverb isn't working, but other controls work fine. It is missing one foot so I ordered a new set.
20240429_191526 by Hentai No Baka, on Flickr
20240429_191532 by Hentai No Baka, on Flickr
20240429_191539 by Hentai No Baka, on Flickr
Randall RG300
- HNB
- PAT. # 2.972.923
- Posts: 13604
- Joined: Tue May 10, 2011 7:55 am
- Location: Puyallup, Washington
- Contact:
Randall RG300
Christopher
Lilith Guitars
Lilith Guitars
- HNB
- PAT. # 2.972.923
- Posts: 13604
- Joined: Tue May 10, 2011 7:55 am
- Location: Puyallup, Washington
- Contact:
Re: Randall RG300
I took the amp apart to look at the reverb tank to see if I could figure out why it wasn't working. Well all four wires in the tank were broken off. I made new leads and reattached the wires to the leads and it is back in business. I also wrapped them in electrical tape, but here are the wires reconnected.
20240527_154901 by Hentai No Baka, on Flickr
20240527_154907 by Hentai No Baka, on Flickr
20240527_154904 by Hentai No Baka, on Flickr
20240527_154901 by Hentai No Baka, on Flickr
20240527_154907 by Hentai No Baka, on Flickr
20240527_154904 by Hentai No Baka, on Flickr
Christopher
Lilith Guitars
Lilith Guitars
- Scout
- PAT. # 2.972.923
- Posts: 991
- Joined: Thu Feb 27, 2020 3:26 pm
- Location: Phillyish
Re: Randall RG300
I can see it now, you're heading down the slippery slope into tube amp repair.
Buckle in
Buckle in
- Scout
- PAT. # 2.972.923
- Posts: 991
- Joined: Thu Feb 27, 2020 3:26 pm
- Location: Phillyish
Re: Randall RG300
Oh , get some shrink tubing instead of electrical tape
for next time.
for next time.
- HNB
- PAT. # 2.972.923
- Posts: 13604
- Joined: Tue May 10, 2011 7:55 am
- Location: Puyallup, Washington
- Contact:
Re: Randall RG300
That would have worked better. I ordered some before, but ended up getting the wrong size so they were way too big. I figured I could always replace the tank, but if I could get it going with a simple solder job, than why not?
This amp is so good, but it is so loud. I have it at like 2.... LOL And that is right before the sound completely cuts out.
This amp is so good, but it is so loud. I have it at like 2.... LOL And that is right before the sound completely cuts out.
Christopher
Lilith Guitars
Lilith Guitars
- Scout
- PAT. # 2.972.923
- Posts: 991
- Joined: Thu Feb 27, 2020 3:26 pm
- Location: Phillyish
Re: Randall RG300
I’ve never had any luck fixing a reverb tank, it’s always been the thinner than a hair
transducer wire that inevitably break.
Yeah, the Randall’s are loud SS amps.
transducer wire that inevitably break.
Yeah, the Randall’s are loud SS amps.
- HNB
- PAT. # 2.972.923
- Posts: 13604
- Joined: Tue May 10, 2011 7:55 am
- Location: Puyallup, Washington
- Contact:
Re: Randall RG300
I got lucky with this one. I think it is funny that in the tank bag is a piece of cardboard with a thin piece of metal stapled to it. I am guessing to block some noise? It doesn't cover the full bottom though. Only like half.
Christopher
Lilith Guitars
Lilith Guitars