Mastery MV Vibrato routing cavity?
Posted: Sat Feb 09, 2019 1:26 pm
I have a Mastery MV vibrato that I plan on using for a custom build, and I'm trying to figure out where to position it in relation to the bridge. Right now, I'm just laying it out in Illustrator, and I'm using a Jaguar template as a guide, but I'm wondering if I should position the top edge of the MV even with where the top edge of the Fender vibrato would be, or should I line it up where the part that holds the strings (whatever that's called) is even with where it would be on a Fender? If I do that, the angle from the bridge to the end of the strings will be the same, but that puts the trem bar back a little further, so I'm not sure what to do.
I emailed Mastery to see if they had a template for it, but I didn't get a response, so I guess I'm on my own on this one. Does anyone have any experience with these?
Images for reference:
Option 1:
Option 2:
I emailed Mastery to see if they had a template for it, but I didn't get a response, so I guess I'm on my own on this one. Does anyone have any experience with these?
Images for reference:
Option 1:
Option 2: