OffsetGuitars.com

j mascis wrote: ↑

Thu Jan 10, 2019 1:53 pm

Do you have access to a local public woodshop? Your city might have one.

I'm not sure, I already did the dremel method and sent it off to MJT. This would have been another good option though.

j mascis wrote: ↑

Thu Jan 10, 2019 1:53 pm

I wonder what spec Saylor is drilling those to because it's not AVRI/US like he says.

I pushed the thimble onto the Saylor drilled hole and it was like...barely too small. Pushing down left just so slight of a ridge. My best guess is that he is using a 23/64" (0.3594") bit or maybe even a "U" (0.368") bit.