Anyone know the center to center spacing?
Fender part number 0053378000
Toronado Bridge Dimensions
- secondhand
- PAT. # 2.972.923
- Posts: 114
- Joined: Mon Jun 30, 2014 7:31 am
- Location: Des Moines, Iowa
Toronado Bridge Dimensions
Good as the best. Bad as the worst!
- Horsefeather
- PAT. # 2.972.923
- Posts: 468
- Joined: Tue Jan 10, 2017 9:47 pm
Re: Toronado Bridge Dimensions
I can't be certain but I suspect the bridge they use on the Bronco bass is the same basic stamping and the one I have of those measures exactly 2 3/4" center to center on the outer holes and the middle hole is exactly 1 3/8" from either.
Incidentally, my plan is to eventually use it as one would a Toronado bridge by modifying the saddle hole locations.
Incidentally, my plan is to eventually use it as one would a Toronado bridge by modifying the saddle hole locations.
- secondhand
- PAT. # 2.972.923
- Posts: 114
- Joined: Mon Jun 30, 2014 7:31 am
- Location: Des Moines, Iowa
Re: Toronado Bridge Dimensions
I was hoping I could do this and the bridge posts were spaced the same or at least close enough a little dremel work could make it fit.
Good as the best. Bad as the worst!
- UC3
- PAT. # 2.972.923
- Posts: 149
- Joined: Sun Jun 21, 2009 7:18 am
- Location: SoCal
Re: Toronado Bridge Dimensions
I currently have both the Bronco bass and Toronado bridge.
Both are 2.75" center to center.
Bronco steel plate is thicker, but footprint and three (3) front-side mounting holes on each baseplate have the same center to center dimension.
Just PM me if you need any other dimensions or images.
Regards,
Mark
Both are 2.75" center to center.
Bronco steel plate is thicker, but footprint and three (3) front-side mounting holes on each baseplate have the same center to center dimension.
Just PM me if you need any other dimensions or images.
Regards,
Mark
- sirspens
- PAT. # 2.972.923
- Posts: 786
- Joined: Sun Nov 08, 2015 8:26 pm
- Location: Austin, Texas
- Contact:
Re: Toronado Bridge Dimensions
That would be fantastic.secondhand wrote: ↑Fri Oct 20, 2017 10:40 amI was hoping I could do this and the bridge posts were spaced the same or at least close enough a little dremel work could make it fit.