Hey guys.
I'm new to this forum, so I don't know if this question has been covered or not but here goes:
I have a PJ bass project going and I'm done with evertything but the soldering.
My problem is this:
I have a Shadow Kill pot for volume, a fender 500k tone pot, og a 3way 4pole rotary switch for a pickupselector. But I cant figure out how to wire the switch
(Keep in mind, its my first time soldering and changing pickup config ).
The combinations I want are:
1) Neck only
2) Neck + Bridge (Or series)
3) Bridge Only
I found this diagram but I'm not shure if it is that simple:
http://i477.photobucket.com/albums/rr13 ... ry4P3T.gif" onclick="window.open(this.href);return false;
Any help would be greatly appreciated!
3way 4pole rotary switch pickup selector.
- Foveon
- PAT PEND
- Posts: 1
- Joined: Tue Jun 23, 2015 9:58 am
- Telliot
- Mods
- Posts: 12207
- Joined: Thu Mar 17, 2011 6:38 pm
- Location: CA
Re: 3way 4pole rotary switch pickup selector.
Firstly, welcome! This is a great forum, full of nice, knowledgeable members.
A while back I wired up a 3-way/4-pole switch and used that same diagram, but found I had to reverse the leads coming from the bridge and neck pickups.
A while back I wired up a 3-way/4-pole switch and used that same diagram, but found I had to reverse the leads coming from the bridge and neck pickups.
The cool thing about fretless is you can hit a note...and then renegotiate.
- 2fLAz
- PAT. # 2.972.923
- Posts: 2780
- Joined: Tue Jan 03, 2012 7:29 am
- Location: France