Yeah I am not particularly concerned. I have a set of .25, .5 and 1" shims from StewMac and used one to replace the cardboard shims originally included in my AVRI Jaguar and feel it's much better solution. The action isn't very high, I figure just 0.5 mm higher than what I like it to be. I may try to lower the bridge after all, but I do like angled necks anyway.Larry Mal wrote: ↑Sun Nov 18, 2018 7:03 amNah, nothing to worry about, it can help your guitar both play and sound better. The only thing I would recommend is that you get a full pocket shim from Stew-Mac, it'll cost a bit, but it'll be better than any solution you'll otherwise find (unless you can make your own full pocket shim).
NGD: Custom Shop Jazzmaster 62 Journeyman
- kgbAttack
- PAT. # 2.972.923
- Posts: 225
- Joined: Mon Dec 11, 2017 10:30 am
- Location: Europe
Re: NGD: Custom Shop Jazzmaster 62 Journeyman
- Pacreamer
- PAT PEND
- Posts: 39
- Joined: Mon Sep 21, 2015 7:44 am
- Location: Front Range, Colorado
Re: NGD: Custom Shop Jazzmaster 62 Journeyman
I sorry for my shim reservations. It’s only because my first real vintage guitar was chock full of shims. At 17 I purchased a 1967 Mustang; it was beat yet unmolested... Err the electronics were original and the finish was as well, but it definetly saw better days. It also didn’t stay in tune for shit but I loved (and still do) it.
When I went it to get setup by Noll Guitars in Cranston, RI, we found newspaper wad shims in the bridge thimble holes, cardboard in neck pocket etc...
I was 17, so immediately made mental connections to hate shims...
When I went it to get setup by Noll Guitars in Cranston, RI, we found newspaper wad shims in the bridge thimble holes, cardboard in neck pocket etc...
I was 17, so immediately made mental connections to hate shims...