help my Rat clone is a Fuzz Factory!

[daydreamdelay]

some people would pay huge amounts of cash for this mod!  


so I finally plugged in the Rat clone I built a few weeks back and something isn't right.. it slips in and out of gating, it's very very strange

anyone have an idea what would cause that? 

[pullover]

Check your voltages with regards to this schematic.

http://www.generalguitargadgets.com/pdf ... ent_sc.pdf

[daydreamdelay]

I went to check last night and couldn't get anything off of the meter this time with the negative lead clipped to the case or grounded jack.. must be a problem there so I suppose I'm going to have to rewire it. all of these pedals have been a guessing game that way since I've skipped the 9v input as I don't use them with od/fuzz/distortion

my Shin Ei isn't working either, definitely my last project for a while.. I'm just not very good at it

[pullover]

can you post pics of the circuit and the wires to it?

[daydreamdelay]

well it's half unwired at this point.. I had two different offboard wiring diagrams to go on and didn't like the one I ended up with, I wired it up the other way first but when it didn't work I tried this one. It ended up being I had the wrong resistors in so maybe that fried something.. I'll finish up wiring it later and see if I can get the meter to work